School of Architecture
Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

To reserve a Rode kit, email archit@syr.edu.

Table of Contents

Steps

  1. Plug the receiver into your computer using the USB-C cable and power it on (power button is on top edge).
    Receiver
  2. There are two wireless mics (transmitters). Turn each one on and they will automatically connect to the receiver (power button is on bottom edge).

    The mic range is fairly good. If meeting at a long table, place a mic at each end. Or pass them around to whomever is speaking.
    Mic (transmitter)
  3. The transmitters can be attached to the mounting stick to use it like a traditional stick mic.
  4. In the Zoom call, change the Audio mic to 'Wireless Go II RX'.

Troubleshooting

  • If the mics are not transmitting sound even though they appear to be set up correctly (and the audio source in Zoom/Teams is set to 'Wireless Go II')

    , check

    • Check to see if

    they
    • the mics are muted.

      Expand
      titleClick here for instructions...
      • On the receiver, look for a small mic icon with a line through it next to the number. This icon shows the mic is muted.
        Image Modified
      To toggle the mute state
      • There are two ways to fix this.
      • Quick method
        • On the transmitter, press the power button once and release quickly. The mute icon on the receiver should disappear.


          Image Added


      • Longer method
        • On the transmitter, press the '1/2' button until a small gray outline appears around the muted mic. 

          Image Modified

          Image Modified
        • Then press the 'dB'
      /mute
        • button to unmute. The mute icon should then disappear.

          Image Modified

      • Note that the mute state will persist through a power on/off.



    • Check to see if the receiver is actually powered on. If you see a battery icon as below, the receiver is powered off (but charging).

      Image Modified
  • Check to see if the mic transmitter is no longer synced to the receiver.

    • On the receiver, the battery and wifi symbol will be empty.
    • On the mic transmitter, the left blue light will blink steadily.

      Image Added

    • To fix:
      • On the receiver, press the 1/2 button until there's an outline around the mic that lost its sync.
      • Now hold the 1/2 button down until the outline starts blinking. 
      • On the transmitter, quickly press the power button twice. (This has to be done before the outline on the receiver stops blinking. If you run out of time, repeat the previous step.)
      • Once the sync is re-established, the left blue light on the transmitter will remain on and stop blinking, and on the receiver the battery and wifi symbols will come to life. 

keywords: microphone